Hard disk needs to slide into the 3.5 inches’ bay area inside the cabinet. Installation and connection of Hard Disk Drive. After inserting the SMPS from inside the cabinet you need to fix four screws to get it fixed. The SMPS is installed on the top area on the back side of cabinet. Just align the RAM according to the cuts shown on RAM and RAM-slots and PRESS it. As you can see in the picture, you need to pull the plastic locks on both the ends of the slot to insert the RAM module.Once it rests on the slot, just press it, the plastic locks will automatically get tightened. The RAM modules are fixed in RAM slots on the motherboard. To fix the fan, you have to push the pins diagonally that means if you press pin number 1, next pin to be pressed is pin-3 and similarly, after pressing pin 2 you need to push pin-4.Īs you can see in the above image, Fan Pins should go in to the holes( dedicated for fan) on the motherboard. To move these pins in their default position, make sure to fully rotate the pins in a clockwise direction. This type of fan consists of 4 Pins on all its corners. Before installing the fan, you need to apply heat sink compound on the upper surface of the processor.ĭepending on the processor type, you need to use different types of cooling fans. A fan is needed to cool down the temperature of a processor. After successfully fixing the processor on the socket you need to pull the socket lever down.Ĭuts/notches as on PIN-less processor typesĬPU is the most heated component of a PC. The CPU socket on the motherboard also has a same type of cut, you just need to match the notch on CPU and motherboard socket while installation. After unpacking the processor carefully, the first and the foremost step is to locate the notch on the side of the processor.
0 kommentar(er)
